Leyland Trade Contract Matt - Pure Brilliant White 10L

Leyland Contract Matt is specially formulated to provide a full bodied, high opacity, matt finish to all interior walls and ceilings making it ideal for new work application. 

Key Benefits:

• Touch-Dry in 2-4 Hours
• Recoatable in 2-4 Hours
• 14m²/Ltr Coverage
• Non-Washable
• For Indoor Use
• Low VOC Level
• Suitable for Walls & Ceilings

Coverage

Leyland Contract Matt will cover approximately 13 square metres per litre depending on the nature and porosity of the surface. When using more than one tin of a colour in the same room, intermix before use. 

Preparation 

All surfaces to be painted should be clean, dry and free from loose and flaking material. Prime where required with Leyland Contract Primer Undercoat. Rub down glossy surfaces with fine waterproof abrasive paper and rinse thoroughly. Avoid the inhalation of dust. Wear a suitable face mask if dry sanding. Seal absorbent surfaces with a solution of up to 1 part water to 9 parts Leyland Contract Matt. 

Application

Stir well before use. Do not thin, except for absorbent surfaces, or when applying by roller or spray when a small quantity of clean water may be added. Suitable for application by brush, roller or spray. Apply paint evenly by brush or roller and avoid overspreading. If required, a second coat may be applied after 2 to 4 hours. Do not apply in temperatures below 10°C

Cleaning

Remove as much product as possible from application equipment before washing. Replace lid firmly. Wash equipment immediately after use with warm soapy water. Some local authorities have special facilities for the disposal of waste coatings. Do not empty product into drains or watercourses

Warning

• Keep out of reach of children. 
• Avoid contact with skin and eyes. 
• Do not ingest. 
• Do not breathe spray. 
• Wear respiratory protection.
• If medical advice is needed have container or label to hand

Stir well before use. Do not thin, except for absorbent surfaces, or when applying by roller or spray when a small quantity of clean water may be added. Suitable for application by brush, roller or spray. Apply paint evenly by brush or roller and avoid overspreading. If required, a second coat may be applied after 2 to 4 hours. Do not apply in temperatures below 10°C